Heavy Duty Equipment Technician Red Seal Exam Prep · Question
A technician is preparing to lift a large engine component using a shop crane. After attaching the lifting chains, what is the critical first step before fully lifting the component?
After attaching the load, a critical first step is to gently lift the component a small distance to test the rigging and ensure stability. This allows for adjus
Start free practice for Heavy Duty Equipment Technician Red Seal Exam Prep
300 questions · no signup required · 40 free questions per day
Question: A technician is preparing to lift a large engine component using a shop crane. After attaching the lifting chains, what is the critical first step before fully lifting the component?
Answer options: ✅ Lift the component a few centimetres off the ground and check for stability.
- Verify the crane's weight capacity against the component's weight.
- Inspect the lifting chains for any signs of wear or damage.
- Clear the area around the component of all personnel.
Correct answer: Lift the component a few centimetres off the ground and check for stability.
Explanation: After attaching the load, a critical first step is to gently lift the component a small distance to test the rigging and ensure stability. This allows for adjustments before a full lift, preventing an uncontrolled swing or tip. While verification of capacity, chain inspection, and clearing the area are all important steps, checking stability immediately after initial lift is paramount for safety.
Start free practice for Heavy Duty Equipment Technician Red Seal Exam Prep
300 questions · no signup required · 40 free questions per day
More about Heavy Duty Equipment Technician Red Seal Exam Prep
Related Questions
- What is the primary purpose of a 'lock-up clutch' in a modern heavy-duty torque converter?
- A technician is performing a visual inspection of a heavy-duty truck's air brake system. Which of the followin
- During a pre-trip inspection of an air-braked commercial vehicle, the operator observes a sudden drop in air p
- A technician is preparing to lift a heavy engine component using a shop crane. The component's manufacturer sp
- A technician has completed a repair on a hydraulic cylinder on a piece of articulated equipment. Before connec
- A technician is installing a new final drive assembly on an excavator. The assembly weighs approximately 250 k
More for Heavy Duty Equipment Technician Red Seal Exam Prep candidates
FAQs
Question explanations
- What is the primary purpose of a 'lock-up clutch' in a modern heavy-duty torque converter?
- A technician is performing a visual inspection of a heavy-duty truck's air brake system. Which of the followin
- During a pre-trip inspection of an air-braked commercial vehicle, the operator observes a sudden drop in air p
- A technician is preparing to lift a heavy engine component using a shop crane. The component's manufacturer sp
Ready to practice?
Free, no signup required. Build a wrong-question list as you go.
Start Free Heavy Duty Equipment Technician Red Seal Exam Prep Practice →Related courses
Other Canadian certifications candidates often prepare for alongside this one.