A telehandler's load chart is based on a standard load centre distance, typically 600 mm for loads up to 5,000 kg. If an operator is lifting a long, irregularly shaped load where its centre of gravity is 1,000 mm from the fork face, what action should be taken?

Question: A telehandler's load chart is based on a standard load centre distance, typically 600 mm for loads up to 5,000 kg. If an operator is lifting a long, irregularly shaped load where its centre of gravity is 1,000 mm from the fork face, what action should be taken?

Answer options: ✅ Consult an attachment capacity plate or perform a recalculation to determine the reduced capacity for this extended load centre.

• Assume the standard capacity applies, as long as the total load weight is below the maximum capacity.
• Add additional counterweights to the telehandler to compensate for the extended load centre.
• Lift the load with the boom retracted to its shortest possible reach to increase stability.

Correct answer: Consult an attachment capacity plate or perform a recalculation to determine the reduced capacity for this extended load centre.

Explanation: An increased load centre distance significantly reduces the telehandler's actual lifting capacity due to a greater overturning moment. The operator must not assume standard capacities apply; instead, they should consult an attachment capacity plate or perform a specific calculation to determine the derated capacity, as required by CSA B354.7 and provincial OHS regulations.