Welder Red Seal · Question
A technician is preparing to perform welding on a piece of equipment situated within 10 metres of a storage area containing flammable liquids. What Canadian standard or regulation specifically mandates the requirement for a hot work permit in this scenario?
The National Fire Code of Canada (NFC) specifically outlines requirements for hot work permits, especially when welding is performed near combustible materials
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
Question: A technician is preparing to perform welding on a piece of equipment situated within 10 metres of a storage area containing flammable liquids. What Canadian standard or regulation specifically mandates the requirement for a hot work permit in this scenario?
Answer options:
- CSA Z462, Workplace electrical safety standard
- CSA B51, Boiler, pressure vessel, and pressure piping code ✅ National Fire Code of Canada (NFC)
- CSA W59, Welded steel construction (conventional construction)
Correct answer: National Fire Code of Canada (NFC)
Explanation: The National Fire Code of Canada (NFC) specifically outlines requirements for hot work permits, especially when welding is performed near combustible materials or in areas with fire hazards. The other standards listed do not primarily govern hot work permits for fire prevention.
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
More about Welder Red Seal
Related Questions
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
- A structural welder is performing overhead FCAW-G on 12 mm (0.5 in) thick steel with an E71T-1 wire. The weld
- A welder is setting up an FCAW-S machine for welding in a remote location without access to external shielding
More for Welder Red Seal candidates
Practice tests
Question explanations
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
Ready to practice?
Free, no signup required. Build a wrong-question list as you go.
Start Free Welder Red Seal Practice →Related courses
Other Canadian certifications candidates often prepare for alongside this one.