Welder Red Seal · Question
When performing oxy-fuel cutting in a remote outdoor area, which of the following is the minimum fire watch requirement according to typical Canadian safety standards?
Typical Canadian safety regulations, often reflected in provincial OH&S codes and fire codes, require a fire watch to remain on duty for a minimum of 30 minutes
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
Question: When performing oxy-fuel cutting in a remote outdoor area, which of the following is the minimum fire watch requirement according to typical Canadian safety standards?
Answer options:
- A designated fire watch for at least 15 minutes after completion of cutting operations. ✅ A designated fire watch for at least 30 minutes after completion of cutting operations.
- A designated fire watch and a fire extinguisher immediately available during the cutting process.
- A designated fire watch equipped with a hose line for at least 60 minutes after cutting.
Correct answer: A designated fire watch for at least 30 minutes after completion of cutting operations.
Explanation: Typical Canadian safety regulations, often reflected in provincial OH&S codes and fire codes, require a fire watch to remain on duty for a minimum of 30 minutes after the completion of hot work operations to ensure no delayed ignition occurs from smouldering materials. While having a fire extinguisher during the process is crucial, the 'after completion' time is specifically regulated.
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
More about Welder Red Seal
Related Questions
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
- A structural welder is performing overhead FCAW-G on 12 mm (0.5 in) thick steel with an E71T-1 wire. The weld
- A welder is setting up an FCAW-S machine for welding in a remote location without access to external shielding
More for Welder Red Seal candidates
Practice tests
Question explanations
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
Ready to practice?
Free, no signup required. Build a wrong-question list as you go.
Start Free Welder Red Seal Practice →Related courses
Other Canadian certifications candidates often prepare for alongside this one.