Welder Red Seal · Question
A contracting company is bidding on a project that explicitly requires all welding procedures and welders to be qualified to ASME Section IX for pressure vessel fabrication. What primary aspect does ASME Section IX govern?
ASME Section IX is the Boiler and Pressure Vessel Code that specifically outlines the requirements for the qualification of welding and brazing procedures, as w
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
Question: A contracting company is bidding on a project that explicitly requires all welding procedures and welders to be qualified to ASME Section IX for pressure vessel fabrication. What primary aspect does ASME Section IX govern?
Answer options:
- Design dimensions and material specifications
- Installation and operational maintenance procedures ✅ Welding and Brazing Procedure Qualifications and Welder/Brazing Operator Qualifications
- Non-destructive examination acceptance criteria
Correct answer: Welding and Brazing Procedure Qualifications and Welder/Brazing Operator Qualifications
Explanation: ASME Section IX is the Boiler and Pressure Vessel Code that specifically outlines the requirements for the qualification of welding and brazing procedures, as well as the qualification of welders and brazing operators. It does not dictate design, installation, or acceptance criteria, which are covered by other ASME sections or codes.
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
More about Welder Red Seal
Related Questions
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
- A structural welder is performing overhead FCAW-G on 12 mm (0.5 in) thick steel with an E71T-1 wire. The weld
- A welder is setting up an FCAW-S machine for welding in a remote location without access to external shielding
More for Welder Red Seal candidates
Practice tests
Question explanations
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
Ready to practice?
Free, no signup required. Build a wrong-question list as you go.
Start Free Welder Red Seal Practice →Related courses
Other Canadian certifications candidates often prepare for alongside this one.