Welder Red Seal · Question
A welding procedure specifies a single-V groove weld with a 60-degree included angle. If the two plates are prepared with symmetrical bevels, what is the bevel angle on each individual plate?
The 'included angle' is the total angle formed between the prepared faces of the two members. For a symmetrical V-groove, each piece is prepared with a 'bevel a
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
Question: A welding procedure specifies a single-V groove weld with a 60-degree included angle. If the two plates are prepared with symmetrical bevels, what is the bevel angle on each individual plate?
Answer options:
- 15 degrees ✅ 30 degrees
- 45 degrees
- 60 degrees
Correct answer: 30 degrees
Explanation: The 'included angle' is the total angle formed between the prepared faces of the two members. For a symmetrical V-groove, each piece is prepared with a 'bevel angle' of half the total included angle, so 60 degrees / 2 = 30 degrees per plate.
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
More about Welder Red Seal
Related Questions
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
- A structural welder is performing overhead FCAW-G on 12 mm (0.5 in) thick steel with an E71T-1 wire. The weld
- A welder is setting up an FCAW-S machine for welding in a remote location without access to external shielding
More for Welder Red Seal candidates
Practice tests
Question explanations
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
Ready to practice?
Free, no signup required. Build a wrong-question list as you go.
Start Free Welder Red Seal Practice →Related courses
Other Canadian certifications candidates often prepare for alongside this one.