Welder Red Seal · Question
Which of the following welding process combinations is generally considered to offer the highest deposition rate in out-of-position welding?
FCAW-G is known for its high deposition rates, even in out-of-position applications, due to the continuous wire feed and the flux that helps with puddle control
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
Question: Which of the following welding process combinations is generally considered to offer the highest deposition rate in out-of-position welding?
Answer options:
- SMAW (Shielded Metal Arc Welding) with E7018 electrodes.
- GMAW (Gas Metal Arc Welding) short-circuit transfer. ✅ FCAW-G (Gas-shielded Flux-Cored Arc Welding).
- GTAW (Gas Tungsten Arc Welding) with cold wire feed.
Correct answer: FCAW-G (Gas-shielded Flux-Cored Arc Welding).
Explanation: FCAW-G is known for its high deposition rates, even in out-of-position applications, due to the continuous wire feed and the flux that helps with puddle control. SMAW and GTAW are generally lower deposition, and GMAW short-circuit is specifically a low heat input process, thus lower deposition than FCAW-G.
Start free practice for Welder Red Seal
154 questions · no signup required · 40 free questions per day
More about Welder Red Seal
Related Questions
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
- A structural welder is performing overhead FCAW-G on 12 mm (0.5 in) thick steel with an E71T-1 wire. The weld
- A welder is setting up an FCAW-S machine for welding in a remote location without access to external shielding
More for Welder Red Seal candidates
Practice tests
Question explanations
- A welder is fabricating a pressure vessel component using FCAW-G with an E70T-1 wire. The procedure specifies
- A welder is preparing to weld 20 mm (0.8 in) thick high-strength low-alloy (HSLA) steel using FCAW-G. The weld
- A structural steel fabricator is using FCAW-S (E71T-8 wire) to weld heavy sections of structural steel in an o
- When performing FCAW-G (gas-shielded flux-cored arc welding), a welder notices the arc is unstable and the wir
Ready to practice?
Free, no signup required. Build a wrong-question list as you go.
Start Free Welder Red Seal Practice →Related courses
Other Canadian certifications candidates often prepare for alongside this one.